With 8cm fan. This will replace ST-250TND, FSP250-50SAV(PF) and FSP220-50LD power supply found in NEC ML250. Will also replace FSP250-50LA 250W power supply ( NEC 6937250200 ). Replacement power supply for NEC Powermate VL6. Possible replacement for FSP200-60SAV(PF) power supply. Also could replace FSP250-50GBC as long as your case can accomodate the fan being 180 degrees opposite to your original part FSP250-50GBC please check.

Specifications: 

Remote ON/OFF Control: The Power supply shall accept a logic open collector level which will disable /enable all out put voltage (excluding +5V standby).

Temperature range: operating 0°C~50°C storage-20°C~+65°C

Temperature coefficient: 0.01%°C

Transient response: output voltage recovers in less than 1 ms max. following a 25% load change

Hold-up time: 17.0 mS minimum at 115V / 60 Hz.
                    17.0 mS minimum at 230V / 50 Hz.

Dielectric withstand: input / output 1800VAC for1 second, input to frame ground 1800VAC for 1 second

Humidity: 5~95% RH

Efficiency: 80% min. at full load

Power good signal: turn-on delay 100ms to 500ms

Over current protection

Over voltage protection: +5V +3.3V +12V

Short circuit protection

Voltage: 110-230VAC (With PFC)

Frequency: 47Hz to 63Hz

Input current: 4 amps maximum / 115 Vrms
                    1.5 amps maximum / 230 Vrms

Inrush current: 50 amps cold, 80 amps warm measured at 230 Vrms

Size  85mm L x 65mm (70mm to top of fan) W x 175mm Deep

1 x 20 + 4way, 3 x HD, 1 x FD, 1 x P4, 2 x SATA connector

DC Lead length 20cms M/B, 30cms HD, FD,12vP4, 60cms Sata.

Fan: 12cm

Part Number: 9PA250CU01